How to replace the atomizing nozzle

Any item that has been used for a long time or is damaged due to incorrect use or other improper reasons needs to be replaced. The same goes for the nozzle, as mentioned aboveWhy do nozzles need regular maintenance and replacement?》Introduced how to judge whether the nozzle should be replaced, todayFine atomization nozzle factoryLet me introduce to you how to replace the atomizing nozzle.

1. Use a flat shovel to clean the top and bottom of the cut within 10 cm, so that the upper and lower outer diameters of the atomizing nozzle are almost the same. After finishing, wipe the interface and surrounding outer walls with a dry cloth to keep away water.

2. Use old parts that can be used to fix them with thick iron wire. Pull the iron wire down through the atomizing nozzle and wrap it around. Fix both ends of the iron wire at a position about 50 cm away from the outlet of the branch pipe. If it is too close, the atomizing nozzle will not be strong, and if it is far away, the iron wire will be wasted. If the atomizing nozzle is on the edge of the branch pipe and the distance is less than 50 cm, you can use a wooden board to support the center of the iron wire and the atomizing nozzle water pipe so that the angle between the iron wire and the nozzle at both ends of the atomizing nozzle is roughly the same to prevent the atomizing nozzle from tilting to one side. Fixing of the new ST-6 atomizing nozzle: Thin iron wire (cloth) can be used to fix the new atomizing nozzle. Directly bypass the upper branch pipe of the atomizing nozzle, pull it over the new atomizing nozzle, tie it up, and then tie the thin iron wire (cloth) to the water pipe with iron wire. Move it up and down to touch the atomizing nozzle with the water pipe and fix it.

3. Mix the glue and an admixture, mix, first brush the upper and lower parts of the fixed atomizing nozzle interface, and then start wrapping the cloth, and apply glue again after every few turns, and apply it evenly. The cloth is wound with different number of turns according to the needs. In the end, a narrow cloth is used, which can tightly wrap the entrance part and fix it very well.

4. Use scissors to cut off the fallen wool ends. After the atomizing nozzle is fixed, it will take about three days for the glue to solidify. However, the condensation time will be different depending on the temperature. The colder it is, the slower the condensation will be.

If you still have any questions, you can call us at 0551-65710970. Welcome to call us for consultation and discussion.