What should I do if the spray width of the fan-shaped nozzle is too small?

There are many models of fan-shaped nozzles. In addition to the standard type, there are also VL-type wide-angle nozzles, VK-type narrow-angle nozzles, etc. However, their principles are the same. They just slightly change the shape to make the spray angle, impact force, droplet size, etc. different, and are suitable for different places. However, the common point is that they all spray fan-shaped sprays. What should I do if the spray width of the fan-shaped nozzle is too small? todayFine atomization nozzle factoryTo answer for you:
1. Jet air pressure is too low

Check whether the operation is according to the standard air pressure

Countermeasures: Operate according to the standard air pressure of the spray gun.

2. The viscosity of the paint is too high

Solution: Add thinner according to the data provided by the paint manufacturer to confirm that the viscosity of the paint is appropriate.

3. The atomization hole in the center of the hood is too worn

Solution: Just replace the nozzle set (nozzle hood and gun needle).
4. The needle stroke is too small

Solution: Turn the paint flow adjustment knob counterclockwise. Increase the needle width stroke.

5. The gun needle is seriously worn

Solution: Replace the nozzle kit.

6. The air input connector has been wrapped with tape, causing the air pipe of the hood fan control air hole to be blocked.

Solution: Disassemble the spray gun and clean the air channel of the spray gun.
7. The air replenishment hole of the watering can cover is blocked.

Solution: Clean the remaining paint from the air supply hole of the spray bottle cover.

8. There is too much paint residue on the paint filter

Solution: Clean or replace the paint net.

Basically, it is caused by the above 8 factors. You can choose the corresponding method according to the corresponding fault.